how to change lazer battery on craftsman 320.10860-01 saw

Daniel Parker

2 min read

·

25-01-2025

1

0

Share

The Craftsman 320.10860-01 saw boasts a helpful laser guide, but like all batteries, it eventually needs replacing. This guide will walk you through the process of changing the laser battery in your Craftsman 320.10860-01 saw quickly and easily. This model uses a common 9V battery.

Tools and Materials You'll Need

Before you begin, gather these items:

• A new 9V battery: Ensure you have a fresh, high-quality 9V battery.
• Phillips head screwdriver: You'll need this to access the battery compartment.

Step-by-Step Guide to Replacing the Laser Battery

Here's how to replace the battery in your Craftsman 320.10860-01 saw:

1. Turn Off and Unplug the Saw: This is crucial for safety. Always disconnect the power before performing any maintenance.

2. Locate the Battery Compartment: The battery compartment is typically located on the bottom or side of the saw's base, near the laser itself. Look for a small access panel or door, often secured with a single screw.

3. Open the Battery Compartment: Use your Phillips head screwdriver to carefully remove the screw securing the battery compartment. Gently open the compartment door or panel.

4. Remove the Old Battery: The 9V battery should be visible inside the compartment. Carefully remove the old battery. Pay attention to its polarity (+ and -) as this is crucial for correctly installing the new one.

5. Install the New Battery: Insert the new 9V battery into the compartment, ensuring the positive (+) and negative (-) terminals align correctly with the markings inside the compartment. Incorrect polarity can damage the laser.

6. Close the Battery Compartment: Replace the compartment door or panel and secure it with the screw.

7. Test the Laser: Plug in your saw and turn it on. Check if the laser is functioning correctly.

Troubleshooting

If the laser still doesn't work after replacing the battery:

• Check Battery Connection: Make sure the new battery is properly seated and making good contact.
• Check Laser Alignment: The laser might be misaligned. Consult your owner's manual for instructions on how to adjust the laser alignment.
• Inspect for Damage: Carefully examine the laser unit and wiring for any signs of damage. If you find any, contact Craftsman customer service or a qualified repair technician.

Maintaining Your Craftsman Saw

Regular maintenance, including timely battery replacements, will keep your Craftsman 320.10860-01 saw functioning optimally and extend its lifespan. Always refer to your owner's manual for complete maintenance guidelines.

Conclusion

Changing the laser battery in your Craftsman 320.10860-01 saw is a straightforward process. By following these simple steps, you can quickly restore the laser functionality to your saw, improving your cutting accuracy. Remember safety first – always unplug the saw before starting any maintenance. If you have any difficulties, consult your owner's manual or contact Craftsman customer support.